How to measure a box

Measuring boxes is as easy as 1-2-3. Box measurements always correspond to the inner dimensions of the box. This is done to ensure a snug and protective fit around your product.

diagram1

Simply measure the length, width, and depth (or height) of what you would like to pack and express the measurements in milimetres. Make sure to give the dimensions in this order:

1. length
2. width
3. depth

Allow a minimum of 3mm extra to each dimension for the fitting . Be sure that the length and width do correspond to the opening of the box.

You can also provide us with a board size of the box. To do this fully open out the carton until it is just a single flat sheet and measure the length and width of the board. This board size is very useful when quoting for die cut boxes. If entering a quote enter flute direction as length and the other direction as width (As style 0110). Leave the depth blank.

Corrugated Carton

This probably is the most common style of box (0201) with fold over flaps to seal at the top and bottom. It is also one of the most economical styles of box in that it produces very little waste and requires no origination for manufacturing unless it is to be printed.

Die-Cuts

A very common style of box that is manufactured with the use of a shaped die-cutting tools. This style of box ensure higher degrees of accuaracy in size and consistancy and allows for almost any shape or style of box to be manufactured. When a special size or style is required a tooling charge will be incurred as a one-off charge.

Standard and Common Styles:

If you're still unsure, then just contact us!
or visit www.webpkg.com